Hauff-Technik HSD100 RW 1x25/32/40+3x6-18 b40 Montageanleitung Seite 11

Press seal with segmented rings
HSD100 RW 1x25/32/40+3x6-18 b40
3 Disassembly takes place in reverse order to assembly.
4 After disassembly, the press seal must be dismantled
into its individual components and recycled according
to the valid environmental regulations.
8 Attaching the FHRK seal
1 FHRK seal
1 Clean an area next to the mounted press seal where
the FHRK seal can be stuck on.
2 Peel off protective foil on the back of the FHRK seal.
1
Art. Nr.: 5090020108 Rev.: 01/2023-08-17
3 Stick FHRK seal on the cleaned area on the wall.
Press seals with segmented rings HSD100 RW
1x25/32/40+3x6-18 b40 are tested by FHRK ac-
cording to current test guidelines and bear the
seal "FHRK Quality". Stick the seal on the inside
wall next to the core drill hole/wall sleeve. This al-
lows you to demonstrate that you are using
tested quality products.
Press seal
Test report number
FHRK standard
Tested for radial load
Service telephone + 49 7322 1333-0
EN
HSD
G 30322-3-3
20, 30, 40
No
Subject to change!
11