Makita DUP361 Betriebsanleitung Seite 18

connection cord
connection with
box
If
blink
the
disconnect the
remove
your local authorized service center for repair.
Lamps
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing the battery holder into the
backpack
►
Fig.9: 1. Clamp 2. Battery holder 3. Strap
1. Pass
through
right
the
2. Pass
the
the
secure
with
sure
holder
backpack firmly.
Installing the holster
►
Fig.10: 1. Holster 2. Strap
Pass the
lower buckle
of the
Adjusting the harness
Adjust the
1. Close
lower
its
1. Lower
2. Adjust
length. ► Fig.12
3. Adjust
the
and
for
the
and the
the lamps
alternately, stop
tool immediately,
connection cord,
the battery,
blink alternately
the switch
the opening
or left)
back pack.
the clamp
square hole
battery holder,
the battery
the strap.
that the
sits in
belt of
through the
holster.
harness as
and lock
buckle, and
length. ► Fig.11:
belt
buckle
the shoulder
the position
upper buckle.
lock the
loose
switch
shears.
still
using CAUTION:
open the lower buckle and upper buckle, loosen
shoulder straps, and set down the backpack.
and ask
Installing the connection cord
CAUTION:
box's I/O switch is on the "O" side before
attaching the connection cord.
CAUTION:
connection cord is damaged.
NOTICE:
away from heat, oil, or sharp edges. Otherwise
Attach
box
the
(either
shears as follows:
of
1.
plug of the connection cord with the triangular mark of
through
the female connector of
of
and
holder
Make
battery
the
coupling with the trianglar marks, and push in and turn
the coupling to tighten.
►
the
NOTICE:
opening
follows:
2.
the
adjust
3.
the cord holder. ►
strap
Hang
either
of
the
Close
the
upper
hung.
18 ENGLISH
buckle and
length. ► Fig.13:
belt
Upper buckle
In case of emergency, quickly
Always make sure that the switch
Do not operate the tool if the
Do not
connection cord.
carry the
pulling the
Keep the
the connection cord
be damaged.
the connection cord
switch box
First, align the triangular marks of the male
box. Push
plug of
connection cord
connector of
box. Then, align the marking on the
Fig.14: 1. Triangular mark 2. Connection
cord 3. Switch box
coupling 5. Coupling
Turn the coupling and align the marking on
the coupling
triangular marks
disconnecting
connection cable.
Hang the
on the
or upper
Push the connection cord into the loop of
Fig.16
the cord
the upper
waist belt
switch box
adjust its
1.
abuse the
Do not
tool by
connection cord.
connection cord
may
with
and the
the switch
in the
the
to the
the switch
4. Marking on
with the
first when
the
switch box
waist belt
belt. ►
Fig.15
holder on
belt or
on which
is not