Makita DUP361 Betriebsanleitung Seite 15

a hot battery cartridge cool down before
charging it.
4. Charge the battery cartridge if you do not use
it for a long period (more than six months).
N Mark
The N Mark is a trademark or registered trademark of NFC
Formula, Inc. in USA and other countries in the world.
(This tool
an
for
used
service
PARTS DESCRIPTION
►
Fig.1
1 Harness *
5 Pilot lamp (green)
9 Connection cord
* The shape may differ depending on the tool variation.
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Removing or installing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery
cartridge firmly when installing or removing
battery cartridge.
the
battery
cause
off
result
the
cartridge
personal
►
Fig.2: 1. Red indicator 2. Button 3. Battery
cartridge
4. Battery holder
is equipped with
NFC receiver
a service
by authorized/factory
centers.)
2 Back pack
6 I/O switch
10 Shears
Failure to
tool and
cartridge firmly
them to
your hands
in damage
tool and
and a
injury.
To
slide
while
the
only
purpose
3 Switch
7 Holster
11 Switch trigger
To
align
battery
in
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper
it
completely.
CAUTION:
fully until the red indicator cannot be seen. If not, it
someone around you.
CAUTION:
forcibly. If the cartridge does not slide in easily, it is
not
NOTE:
hold
the
may
Tool / battery protection system
slip
and
The
to
a
battery
automatically cuts off power to the motor
extend
The
stop
tool
of the following conditions. In some conditions,
15 ENGLISH
remove the
it from
sliding the
front of
box 4
8
-
install the
the tongue
cartridge with
the housing
side of
is not
Always install the battery cartridge
may accidentally
out of
causing injury
Do not install the battery cartridge
being inserted
The tool
work with
battery cartridge.
tool is
tool/battery protection system. This system
tool and
tool will
during operation if
or battery
battery cartridge,
the tool
button on
the cartridge.
Pilot lamp (red)
Cord holder
-
battery cartridge,
on the
the groove
and slip
the button,
locked
fall
the tool,
to you or
correctly.
does not
only one
equipped with
to
battery life.
automatically
the
is placed under one