Makita DUP361 Betriebsanleitung Seite 17

►
Fig.4: 1. I/O switch 2. Pilot lamp (green) 3.
Pilot lamp (red)
3. The
locked-mode
I/O
pull the switch trigger two
upper
automatically.
4. To
blade,
trigger. ► Fig.5:
For safety reasons, the tool shifts into locked-mode or
shut-off mode automatically if the tool is left untouched
for a certain period of time.
After 5 minutes: The tool shifts into locked-mode. Pull
the switch trigger two times to release the lock.
After 15 minutes: The tool is shift into shut-off mode,
and the green pilot lamp turns off. Press the I/O switch
to the "O" (off) position once, and press the I/O switch to
the "I" (on) position again, then pull the switch trigger
two times to release the lock.
Opening angle selector lever
►
Fig.6: 1. Opening angle selector lever
By tilting the opening angle selector lever to the left
side, you
upper shear
the upper
opening angle,
switch trigger fully, and then return the opening angle
selector lever to straight position.
Cutting depth adjustment
CAUTION:
Do not let your hands or part of
body close to the shear blades. Otherwise
personal injury may result.
After sharpening or
shear blade,
necessary.
Turn on the tool, and pull the switch trigger two times to
open the
then press
the "O" (off) position.
to
To deepen the cutting depth, turn the cutting depth
adjusting screw
hex wrench.
cutting depth shallower, turn the cutting depth adjusting
screw counterclockwise.
►
Fig.7: 1. Cutting
screw
NOTE: Check
after
the
shear blades
when
switch is on. To release the lock,
times.
shear blade
close the
pull the
1. Switch trigger
can open
blade wider. To limit
shear blade
first pull
replacing
adjust cutting depth if
shear blades,
the I/O
clockwise with
And to
depth
the cutting
adjustment.
cutting depth
are
Pilot lamps on the switch box
the
►
The
opens
The green and red lamps indicate as follows:
(On: Off:
shear
•
switch
Green lamp lights up: the tool is turned on.
•
Green lamp and red lamp light up: if you insert the
battery
the I/O switch to the "O" (off) position once, and
press the I/O switch to the "I" (on) position again.
the
the
•
Green
•
the
Green
and
switch
the
make the
adjusting
•
Green
depth
If
is
17 ENGLISH
too shallow,
may not
Fig.8: 1. I/O switch 2. Pilot lamp (green) 3.
Pilot lamp (red)
Blinking: )
Green
to
holder when
"I"
is
both of
light up
blade does
though you
switch trigger. In this situation, press
Green
lamp
tool is
Let the
down before
tool on
Green
lamp
and red
or lights
is low
flat. Charge
When either
battery becomes
red lamp
one of
is full.
Green
lamp
lamp blink
tool detects
wire. Check
the branch
cut fully.
Red
the battery
I/O switch
(on) position,
the lamps
and the
not move
pull the
Red
blinks: the
overheated.
tool cool
turning the
again.
Red
lights up
lamp blinks
up: battery
or almost
the batteries.
of the
low, the
blinks even
the batteries
Red
and red
alternately: the
breaking of
the