•
After teaching-in, the device LED of the switch actuator will stop
flashing.
After successfully teaching-in the device, it can be switched on and off
e.g. by a HomeMatic remote control.
If no teach-in operations are carried out, teach-in mode is
exited automatically after 20 seconds. If other devices are also
in teach-in mode, they will be taught-in.
5.2.2
Teaching-in to a HomeMatic Central Control Unit
Your device can be conveniently
•
controlled and configured,
•
connected directly to other devices or
•
used in Central Control Unit programs
by using the HomeMatic software "WebUI". Therefore, your switch ac-
tuator has to be taught-in to the HomeMatic Central Control Unit first.
New devices are taught-in to the Central Control Unit via the Home-
Matic „WebUI".
As soon as a device has been taught-in to a Central Control
Unit, it can only be connected to other components via this
unit.
Start-up
27