4
General information about the HomeMatic
system
This device is part of the HomeMatic home control system and works
with the bidirectional BidCoS
All devices are delivered in a standard configuration. The functionality
of the device can also be configured with a programming device and
software. The additional functions that can be made available in this
way and the supplementary functions provided by the HomeMatic sys-
tem when it is combined with other components are described in the
HomeMatic WebUI Manual.
All current technical documents and updates are provided in the down-
load area at www.homematic.com.
5
Start-up
5.1
Simple operating functions on the device
•
Insert the wireless switch actuator into a socket.
The device is immediately ready for operation and can be taught-in to a
HomeMatic CCU (or to other HomeMatic devices).
Via the channel button (A), connected loads can be controlled (switch
on and off) with a short button press.
Before being able to use and configure your device in the HomeMatic
system, the switch actuator has to be taught-in first (see sec. „5.2 Tea-
ching-in" on page 25).
5.2
Teaching-in
Please read this entire section before starting the teach-in
procedure.
To integrate the switch actuator into your HomeMatic system and en-
able it to communicate with other HomeMatic devices (e.g. HomeMatic
General information about the HomeMatic system
wireless protocol.
®
25