KERN&SOHN ABT-NM Betriebsanleitung Seite 125

13.6 Capacity display
This function displays a bar graph representation of the load on the weighing plate.
This may be used to prevent sudden appearance of "oL" (overload) during
measurement.
It is possible to turn the display of capacity on or off.

ABT-NM-BA-e-1622
Repeatedly press the [CAL] key until "FUnC.SEL" appears.
Press [TARE] key
Repeatedly press the [CAL] key until the current "AdiSP:**" set-
ting appears.
Press [TARE] key
You can use the [CAL] key to select between the following set-
tings:
"Ad-on" Function activated
"Ad-oF" Function deactivated
The current setting is indicated by the standstill display ( ).
Confirm your selection by pressing the [TARE] key
To exit the function, press the [ON/OFF] key.
Brief actuation of ON/OFF key:
Back to previous menu.
Long actuation of ON/OFF key:
Back to weighing mode.
Display will appear when about one third of capacity is
exhausted.
53