Herunterladen Diese Seite drucken

Christopeit Sport EL8000 Montage- Und Bedienungsanleitung Seite 19

Crosstrainer-ergometer

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

GB
STEP 5
Installation of the footrests (41) and handle grip (3).
1. Put one spring washer (21) and one washer 8//16 (32) onto
each screw M8x20 (28).
2. Place the handle grip (3) against the support (13) so that
89
the holes are aligned and push the screws (28) through the
13
3
holes and tighten the handle grip (3) at support (13) firmly.
3. Push the right footrest (41R) onto the right footrest holder
(42R). Adjust the holes in the parts so that they are aligned.
(Note: The position adjusted in this way should always be equal
at both sides. The right and left footrests can be discerned
by the edges of the longitudinal sides of the footrests. The
high edges of the footrests (41) must point inwards (towards
28
32
the main frame(52)). The positions can change as desired at
21
all times by removing the carriage bolts (25) and sliding the
footrests on the footrest holders to get a comfortable exercise
position close to the hand grip. Likewise, the foot rests for a
narrower or further stand on the foot pedals.)
41L
4. Push a spring washer (21) and a washer 8//19 (29) onto
each screw M8x45 (25), push them through the holes and
tighten the foot rest (41R) at foot rest holder (42R) firmly.
5. Install the left footrest (41L) on the left footrest holder (42L)
42R
as described in 3.- 4.
52
41R
29
25
21
89
STEP 6
30
10
Attach the computer (1), the cover (6) and AC adapter (88).
1. Remove the screws (2) from backside of computer (1)
2. Put the plug of connection cable (30) into the plug from
computer (1) backside.
3. Insert the plug of pulse connection cable (10) to the jack
6a
of the computer (1) and attach the computer (1) to top monitor
bracket of support (13) with screws (2). (Ensure that the cable
loom are not crunched or pinched during installation.)
7
4. Remove the screws (7) from support (13) and use them
to mount the computer cover set (6a+6b) to the support (13).
5. Put the plug of AC adapter (88) into the socket (54) at rear
end of chain cover (85).
13
6. Connect with the cable the AC adapter (88) and with jack
of wall power (230V~/50Hz).
88
85
54
19

Werbung

loading

Diese Anleitung auch für:

2229