eta Fenite Bedienungsanleitung Seite 18

EN
III. INSTRUCTIONS FOR USE
Before using the appliance, its battery must be charged first. Charging is possible with the enclosed USB cable from
the mains, i.e. an AC adapter, or a backup power source.
CHARGING
– Before the first use or if the appliance was not used for a long time, charge it completely.
– The standard charging time is approximately 2 hours and the fully charged accumulator allows for the operating
time of 45-170 min (based on set regime). The operating time decreases depending on the appliance loading and
due to the accumulator ageing and wear and tear.
1. Connect the machine via USB cable C to the electrical source (charger). The appliance cannot be used while
charging.
2. Do not exceed the designated charging time!
The status and charging progress of the accumulator is shown on the display using the B4 indicator. Blinks
while charging and stays on when fully charged. A discharged battery is signaled by the blinking of the B4
Optimise the battery service life
– Do not leave USB cable connected to the appliance.
– During charging or regular operation, the appliance heats up, which is
a normal phenomenon, and not a reason for a complaint.
CONTROL
On/off button + setting operation modes (A1)
– By long pushing of button A1 (approx. for 2 sec.) you switch the appliance on/off. Upon switching on and off an
acoustic signal sounds.
– Press short A1 button to switch over the modes. – The operation mode you have set is shown on display B by
lighting up its name (CLEAN / EMS / HOT).
MODES OF OPERATION AND THEIR USE
The appliance contains 3 different modes with different manifestations. Each works with a different color, intensity
of vibration and electricity. pulses (including positive and negative ions), possibly by temperature. To activate the
function, it is necessary to hold the body of the product (thereby touching the A5 belt sensor and closing the loop).
We recommend that the process be carried out gradually as shown in Fig. 2.
Each mode can only be used once a day, at the same time we recommend using all three modes
consecutively within one treatment cycle.
Fotons therapy
Red light – effectively penetrates deep into the skin, revitalizes collagen, softens wrinkles, reduces pigmentation,
increases the efficiency of absorption of cosmetic products, improves blood circulation in the subcutaneous tissue.
Blue light – it facilitates the synthesis of collagen, rejuvenates the skin, removes sagging skin, softens skin pores, has
an antibacterial and anti-inflammatory effect, and contributes to soothing the skin (most suitable for oily, sensitive and
acne-prone skin).
Green light – supports standard cell function, accelerates lymph circulation, reduces swelling and soothes the skin.
Note
indicator during operation.
18 / 39