HIKOKI SV 12SG Bedienungsanleitung Seite 4

English
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
MOUNTING AND OPERATION
Action
Installing the sanding paper
Attaching the dust bag
Switching on and off
How to hold the orbital sander
Attaching a Sponge Pad or a Stick-
on pad (optional accessories)
Making a Hole in the Sanding Paper
with the Punch Plate (optional
accessories)
Selecting accessories
SANDING PAD AND SANDING PAPER SELECTION
Type
Perforated felt pad
Perforated magic pad
Perforated stick-on
pad
Perforated round pad
MAINTENANCE AND INSPECTION
1. Empting and cleaning the Dust Bag
If the dust bag contains too much saw dust, dust
collection will be aff ected. Empty the dust bag when it
gets full.
Remove the dust bag, open the fastener, and dispose of
the contents.
2. Inspecting the sanding paper
Since use of worn-out sanding paper will degrade
effi ciency and cause possible damage to the pad,
replace the sanding paper as soon a excessive abrasion
is noted.
3. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
4. Maintenance of the motor
The motor unit winding is the very "heart" of the power
tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
Figure
1
2
3
4
5
6
―
Sanding pad
Papar mounting
Spring clip
Presser sensitive
Self adhesive
Self adhesive
How to move the orbital sander
For optimum operating effi ciency, alternately move the
sander forward and backward at a constant speed and
balance.
After installing new sanding paper
Movement of the sander may tend to become unsteady
after new sanding paper has been installed, because of
the new, coarse grain of the paper. This can be avoided
Page
by slightly tilting the sander forward or backward during
sanding or polishing. Sander movement will become
94
steady as the sanding paper surface becomes properly
94
abraded.
94
94
95
95
96
Code No.
310354
310355
311978
310356
5. Replacing supply cord
If the supply cord of Tool is damaged, the Tool must be
returned to HiKOKI Authorised Service Center for the
cord to be replaced.
6. Servicing
Consult an authorized Service Agent in the event of
power tool failure.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
GUARANTEE
We guarantee HiKOKI power tools in accordance with
statutory/country specifi c regulation. This guarantee does
not cover defects or damage due to misuse, abuse, or
normal wear and tear. In case of complaint, please send
the power tool, undismantled, with the GUARANTEE
CERTIFICATE found at the end of this Handling instruction,
to a HiKOKI Authorized Service Center.
4
Sanding paper
Grid No. Code No.
AA60
AA100
AA150
AA60
AA100
AA150
AA60
AA80
AA100
AA120
AA150
AA180
AA60 310353
310341
310342
310343
310344
310345
310346
310347
310348
310349
310350
310351
310352