Taurus Alpatec VILNA 600 P Bedienungsanleitung Seite 16

appliance it should be situated in a place where
the atmospheric temperature is between 12 and
32ºC.
-
pliance and so as to be able to install the appli-
a window. But never obstructing or covering a
ventilation area.
- The appliance should work well with its wall
support attached or with its base/feet attached.
ASSEMBLING THE WALL BRACKET:
-
can be supported.
- Taking into account the separation distances
mentioned above, place the wall support in the
required position and mark the drilling points on
- Drill into the wall where marked and insert the
- Place the support by matching the holes with
-
should be able to support twice the weight of the
appliance.
- Fit the appliance into the wall support.
- Take 1 long bracket on the back housing, align
- Before Insert the expansion bolts to the wall,
please make sure the distance between bolts as
below table:
Model Distance
Vilna 600 139mm
Vilna 900 226mm
Vilna 1200 313mm
Vilna 1500 400mm
Vilna 2000 574mm
-
- Fix the short bracket in right position.
-
- Fix the last hole on long bracket after hanging
FITTING THE BASE FEET:
- To assemble the base feet, place the appliance
face down.
- Loosen the screws provided with the appliance
-
-
-
-
- Position the base feet on the body of the
- Stand the appliance up again so as to check
that the base feet work properly.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has
been removed.
- Prepare the appliance according to the function
you wish to use:
USE:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off switch
- Once connected to electricity, the clock will
pop out on the display for setting. Press
toggle among hours / minutes / day. Press the
to set the hours / minutes / day.
-
the appliance will enter to standby mode as
defaulted.
-
mode.
- In case of power failure, after reconnecting the
power supply, set the time again and the unit
will be in standby mode. You can press the
temperature before power failure.
WORKING MODE SETTING
-
modes: Economic mode
, Comfort mode
- Under the mode of comfort mode or economic
or to choose the desired temperature. After
- When the room temperature is higher than
the selected temperature, the heater will stop
heating.
- Comfort mode (setting the desired tempera-
- Economic mode (setting the desired tem-
- Anti-freeze mode (the device mantains the
to
, Anti-freeze mode
, P1/P2/P3.