Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Step 3: Installing the blind frame
Warning: Risk of injury!
Always wear safety gloves!
•
Apply pressure to the springs, until they engage in the retainer.
Warning: Risk of crushing due to springs jumping back. Do not reach
into the clamping area of the springs!
•
Fit an unlocking device at the kink in each spring and allow to hang out of
the frame cut-out.
•
Positioning the frame: Position the pre-tensioned spring tips in the gap of
the heater cover.
•
Press the blind frame against the cut-out in the ceiling
•
Pull the unlocking devices down and allow each of the springs to snap
against the mounting frame.
Note: Store the unlocking devices carefully somewhere for subsequent
removal and re-installation.
Removal:
• Pull the blind frame at the outer edge from the ceiling until the clamping springs
can be reached in the gap.
Warning: Risk of injury!
Always wear safety gloves!
• Press the springs back and swivel the frame out of the installation space. Slow-
ly release the springs.
135
Werbung
