Solamagic IR05026 Montage- Und Gebrauchsanleitung Seite 134

3b. Blind frame variant:
Step 1: Preparing the installation space
• Make a cut-out in the ceiling with dimension (x) mm and (y) mm:
Heater type
IR 05026; IR 05027
IR 05028; DS 05028
• Place the mounting frame behind the ceiling so that the inner lugs are inserted
into the cut-out.
• Centre the mounting frame over the cut-out and on the front side screw to the
ceiling plate using the inner lugs.
• Center the mounting frame in the cutout and screw it to the front panel with
the ceiling plate. For thin ceiling panels (< 15 mm), bend or remove the
mounting tabs if necessary. (Detail A)
Step 2: Mounting the heater in the installation space
• Make the electrical connection to the device, but do not switch on.
• Screw the heater to the mounting frame using 6 M 4 x 18 screws and washers.
• Tighten the screws
Ceiling cutout
in mm
Width (x)
300
300
134
Length (y)
625
850
Detail A