Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Step 3: Installing the heater on the wall mounting
• Push the securing lugs (3) with the ring (4) from the left side into the dovetail
groove for approx. 220 mm
• Tighten the 3.5 x 6.5 screw (5).
• Align the eccentric tensioner (7) of the adapter claw (6) in the vertical direction
(C), see figure below.
• Attach heater (B) at the top in the hammer groove side on the adapter claw (6)
and swing in at the bottom on the eccentric tensioner side (7).
Warning: The adapter claw must now engage in each of the two device
grooves (visual check)
• Tighten the eccentric tensioner (7) by turning the supplied 5 mm hex-key in
a clockwise direction (approx. 80° angle of turn). The heater must be tightly
connected to the adapter claw so that it is free from play.
Attention: there is no rotation-stop; do not turn through 180° – do not
over-turn the eccentric spanner!
• Fit the retaining ring (4) in the cut-out (A) of the adapter claw (6).
• To set or adjust the direction of radiation, use a 5 mm Allen key to loosen
the screws (11), shift the heater into the required direction and re-tighten the
screws (11).
5
3
15
5
3
15
7
128
3
B
6
11
6
11
7
7
3,4,5
7
C
5
B
15
3,4,5
A
4
A
3
C
4
3
Werbung
