Shearing machine Favorita II, Favorita Speed, Electra® II, Ehmann turbo-line®
4.3.3 Sharpening the cutting plate
Note
For sharpening the cutting plate, please contact Tech-
nical Service, see section Technical Service.
4.3.4 Disassemble the shearing head
Risk of injury caused by sharp cut-
ting plates!
Handle the shearing head of the
device with appropriate caution.
WARNING
Loosen knurled screw 14 with leaf spring 15.
Push upper cutting plate 17 under pressure
piece 13 out of the shearing head.
This completes the mounting of the shearing head.
4.3.5 Lubricating the shearing head
Disassemble the shearing head, see section Disas-
semble the shearing head.
Clean upper cutting plate 17 and lower cutting
plate 18 with a soft wipe or brush. Make certain
the gaps in serration 16 are cleaned properly.
Slightly lubricate upper cutting plate 17 and lower
cutting plate 18 with special lubricant for shearing
heads GT604.
6
5.
Reprocessing
Damage to, or destruction of the
product
cleaning/disinfecting or steriliza-
tion!
CAUTION
Only clean and disinfect the
product manually.
Do not sterilize the product
under any circumstances.
5.1 Cleaning/disinfection
Note
Always follow disposal and hygiene instructions and
regulations!
Cleaning/disinfection
Risk of electric shock and fire haz-
ard!
Unplug the device before clean-
DANGER
ing.
Ensure that no fluids will pene-
trate the product.
Leave the product exposed to
air for at least 1 minute after
cleaning/disinfecting.
Damage to the product due to
incorrect cleaning or inappropriate
cleaning/disinfecting agents!
CAUTION
Use any commercial detergent
for surface cleaning.
Never immerse the product in
water or detergent.
caused
by
mechanical