3.
Preparation and setup
Non-compliance with these rules will result in com-
plete exclusion of liability on the part of Aesculap.
Always observe the following guidelines when set-
ting up and operating the product:
– national regulations for installation and opera-
tion,
– national regulations on fire and explosion protec-
tion.
– operating advisories according to IEC-/VDE regu-
lations.
Fire and explosion haz-
ard!
Do not operate the
DANGER
product in explosion-
hazard areas.
Risque
d'explosion!
Ne pas utiliser le
DANGER
produit
zones
d'explosion.
d'incendie
et
dans
des
à
risque
Malfunction
damage to the product
caused
CAUTION
setup!
Do not expose the
product
sunlight or moisture.
Do not cover the
ventilation slots of
the product.
Connect the product
to the specified volt-
age of 100 V to
240 V/50 Hz
60 Hz.
Ensure
mains power socket
used for supplying
the product is freely
accessible.
of,
or
by
improper
to
direct
to
that
the
29