23.3.3 Sharpening the cutting plate
Note
For sharpening the cutting plate, please contact Tech-
nical Service, see section Technical Service.
23.3.4 Disassemble the shearing head
Risk of injury caused by
sharp cutting plates!
Handle the shearing
WARNING
head of the device
with
caution.
Loosen knurled screw 14 with leaf spring 15.
Push upper cutting plate 17 under pressure
piece 13 out of the shearing head.
This completes the mounting of the shearing head.
23.3.5 Lubricating the shearing head
Disassemble the shearing head, see section Disas-
semble the shearing head.
Clean upper cutting plate 17 and lower cutting
plate 18 with a soft wipe or brush. Make certain
the gaps in serration 16 are cleaned properly.
Slightly lubricate upper cutting plate 17 and lower
cutting plate 18 with special lubricant for shearing
heads GT604.
24. Reprocessing
CAUTION
appropriate
Damage to, or destruc-
tion of the product
caused by mechanical
cleaning/disinfecting or
sterilization!
Only clean and disin-
fect
the
manually.
Do not sterilize the
product under any
circumstances.
product
17