Aesculap Favorita II Gebrauchsanweisung Seite 33

Note
The device ships without any blade. Instead, there is a
range of blades available for various applications!
 Slide On/Off switch 3 upward to switch on the
device.
 Push lever 1 towards the shell of the product.
 Mount the shearing head on shearing adapter 2.
 Release lever 1.
This completes the mounting of the shearing head.
4.2 Function Check
 Carry out a visual inspection.
 Check the switch position.
 Mount the blade correctly and lubricate it if neces-
sary, see section Safe handling Shearing head.
4.3 Safe handling Shearing head
4.3.1 Adjusting the plate pressure
Note
The plate pressure can be adjusted to increase the cut-
ting power as required (see foldout page)!
 Tighten knurled screw 14 so that upper cutting
plate 17 can be moved by hand, by applying mod-
erate, lateral pressure.
4.3.2 Adjust plate pressure with Torqui pre-
cision adjusting aid
Note
The manufacturer recommends using the Torqui preci-
sion adjusting aid for optimal adjustment of the plate
pressure.
 Insert Torqui precision adjustment aid 19 into the
socket hex of the knurled screw 14 and turn clock-
wise until a click can be heard.
Note
Knurled screws of older shearing heads that do not have
a socket hex can be retrofitted with the screw set
GT141.
4.3.3 Sharpening the cutting plate
Note
For sharpening the cutting plate, please contact Tech-
nical Service, see section Technical Service.
4.3.4 Disassemble the shearing head
Risk of injury caused by
sharp cutting plates!
 Handle the shearing
WARNING
head of the device
with
caution.
Risque de blessure par
les peignes acérés!
 Manipuler la tête de
AVERTISSEMENT
tonte de l'appareil
avec précautions.
 Loosen knurled screw 14 with leaf spring 15.
 Push upper cutting plate 17 under pressure
piece 13 out of the shearing head.
This completes the mounting of the shearing head.
appropriate
31