Hitachi DS 18DJL Bedienungsanleitung Seite 10

English
3. Do not use an apparently damaged or deformed battery.
4. Do not use the battery in reverse polarity.
5. Do not connect directly to electrical outlets or car
cigarette lighter sockets.
6. Do not use the battery for a purpose other than those
specifi ed.
7. If the battery charging fails to complete even when a
specifi ed recharging time has elapsed, immediately stop
further recharging.
8. Do not put or subject the battery to high temperatures or
high pressure such as into a microwave oven, dryer, or
high pressure container.
9. Keep away from fi re immediately when leakage or foul
odor are detected.
10. Do not use in a location where strong static electricity
generates.
11. If there is battery leakage, foul odor, heat generated,
discolored or deformed, or in any way appears abnormal
during use, recharging or storage, immediately remove it
from the equipment or battery charger, and stop use.
SPECIFICATIONS
POWER TOOL
Model
No-load speed (Low/High)
Wood
(Thickness 18 mm)
Drilling
Metal
(Thickness 1.6 mm)
Capacity
Machine screw
Driving
Wood screw
Rechargeable battery
Weight*
*Weight: According to EPTA-Procedure 01/2003
CHARGER
Model
Charging voltage
Weight
10
DS14DJL
30 mm
6.0 mm (diameter) × 75 mm (length)
(Requires a pilot hole)
BSL1415: Li-ion
14.4 V (1.5 Ah 4 cells)
UC18YKSL
14.4 V ― 18 V
0.35 kg
CAUTION
1. If liquid leaking from the battery gets into your eyes, do not
rub your eyes and wash them well with fresh clean water
such as tap water and contact a doctor immediately.
If left untreated, the liquid may cause eye-problems.
2. If liquid leaks onto your skin or clothes, wash well with
clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
3. If you fi nd rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using the
battery for the fi rst time, do not use and return it to your
supplier or vendor.
WARNING
If a conductive foreign matter enters in the terminal of lithium
ion battery, the battery may be shorted, causing fi re. When
storing the lithium ion battery, obey surely the rules of
following contents.
○ Do not place conductive debris, nail and wires such
as iron wire and copper wire in the storage case.
○ To prevent shorting from occurring, load the battery
in the tool or insert securely the battery cover for
storing until the ventilator is not seen. (Fig. 1)
0 – 450 / 0 – 1250 min
Steel: 13 mm
Aluminum: 13 mm
6 mm
6.8 mm (diameter) × 50 mm (length)
BSL1425: Li-ion
14.4 V (2.5 Ah 4 cells) 18 V (1.5 Ah 5 cells)
1.6 kg
STANDARD ACCESSORIES
1 Plus driver bit (No. 2) ........................... 1
DS14DJL
2 Charger ............................................... 1
(2LEGK)
3 Battery (BSL1415 or BSL1815) ........... 2
DS18DJL
4 Plastic case ......................................... 1
(2LEGK)
5 Battery cover ....................................... 1
1 Plus driver bit (No. 2) ........................... 1
DS14DJL
2 Charger ............................................... 1
(2LFGK)
3 Battery (BSL1425 or BSL1825) ........... 2
DS18DJL
4 Plastic case ......................................... 1
(2LFGK)
5 Battery cover ....................................... 1
Standard accessories are subject to change without notice.
DS18DJL
-1
38 mm
(Requires a pilot hole)
BSL1815: Li-ion BSL1825: Li-ion
18 V (2.5 Ah 5 cells)
1.7 kg