Gastroback 46013 Bedienungsanleitung Seite 67

Problem
After some time of sto-
rage, the container is filled
with gas again.
Even after installing the
locking pins, the lid can
be moved manually.
After unplugging the appli-
ance, the LCD display is
still lit.
Possible Reasons
The food sealed is not sui-
ted for vacuum packaging.
The food has gone bad.
The vacuum container is
not airtight.
The locking pins are not
fixed correctly to the locks in
the base of the appliance.
The locking pins or locks
of the appliance are
damaged.
It will take some seconds
until the LCD display gets
dark.
The Easy Solution
Naturally, some types of food produce gases during sto-
rage. These foods are not suited for vacuum sealing (see:
'Tips for Best Results').
Perishable food produces gases when going bad.
In these cases, discard the food!
Ensure that the lid seal of the container and the rim of
the container and container lid are completely clean. If
required, replace the seal.
Ensure that the vacuum container is completely undama-
ged and without any cracks, scratches and deformation.
If in doubt, use another container.
Possibly, you need to position the locks correctly, before
installing the locking pins. Connect the appliance to the
mains power supply. Then touch the contact bar to clo-
se the lid ("CLOSE"). Touch the contact bar again to
re-open the lid. Thereafter, the locks will be positioned
correctly. Insert the locking pins and carefully check,
whether the lid is fixed to the locks now.
Contact your vendor for examination and repair.
This is normal. Wait some seconds.
67