Inhaltsverzeichnis; General Information - Stiga ST 615 Li Gebrauchsanweisung

WARNING!: READ THOROUGHLY THE INSTRUCTION BOOKLET
EN
BEFORE USING THE MACHINE. Keep for future reference
INDEX

1. GENERAL INFORMATION ........................... 1

2. SAFETY REGULATIONS .............................. 2
3. GETTING TO KNOW THE MACHINE ........... 5
3.1 Description of the machine and planned
use ........................................................ 5
3.2 Safety signs .......................................... 6
3.3 Identification label ................................ 6
4. ASSEMBLY ................................................... 7
5. CONTROLS.................................................. 8
5.2 Starter lever ........................................... 8
5.3 Starter lever lock ................................... 8
5.4 Discharge chute adjustment handle ...... 8
5.5 Deflector adjustment ............................. 8
5.6 Led lights switch .................................... 8
6. USING THE MACHINE ................................. 8
6.1 Preparation ........................................... 8
6.2 Safety checks ........................................ 8
6.3 Start-Up / Operation .............................. 9
6.4 Stop ...................................................... 9
6.5 Advice for operation .............................. 9
6.6 After operation ...................................... 9
7. BATTERY RECHARGING AND
MANAGEMENT ............................................ 9
8. MAINTENANCE ......................................... 10
8.1 General information ............................. 10
8.2 Cleaning .............................................. 10
9. STORAGE .................................................. 11
10. ASSISTANCE AND REPAIRS ..................... 11
11. W ARRANTY COVERAGE .......................... 11
12. MAINTENANCE TABLE .............................. 12
13. PROBLEM IDENTIFICATION ..................... 12
1. GENERAL INFORMATION
1.1 HOW TO READ THE MANUAL
Some paragraphs in the manual contain important
information regarding safety and operation and
are emphasized in this manner:
NOTE or IMPORTANT these give details
or further information on what has already been
said, and aim to prevent damage to the machine.
The symbol highlights danger. Non-
compliance with the warning could lead to
personal or third party injury and/or damage.
The paragraphs highlighted in a square with
grey spots indicate the optional characteristics
not on all models documented in this manual.
Check if the characteristic is on this model.
Whenever reference is made to a position
on the machine "front", "back", "left"
or "right" hand side, this is determined
from where the operator is driving.
1.2 REFERENCES
1.2.1 Figures
The figures in these instructions for
use are numbered 1, 2, 3, etc.
Components shown in the figures are marked A,
B, C, etc.
A reference to component C in figure 2 is
written: "See fig. 2.C" or simply "(Fig. 2.C)".
The figures are given as a guide only. The
actual parts may vary from those shown.
1.2.2 Titles
The manual is divided into chapters and
paragraphs. The title of paragraph "2.1 Training" is
a sub-title of "2. Safety regulations". References
to titles or paragraphs are marked with the
abbreviation chap. or par. and the relevant
number. Example: "chap. 2" o "par. 2.1".
EN - 1