Under Operation; Cleaning And Maintenance; Technical Specifications - Texas Pro Cut 460 Bedienungsanleitung

Under Operation

The lawn spiker is used to loosen moss, etc. from the lawn. The machine's blades rotate in
the direction of travel, thereby helping to propel the machine forward.
Note! Only use it early spring og late autumn, where the soil is soft and moist.
Start the motor and lower the machine to the "work" position using the handle on the right
hand side of the machine. Activate the clutch trigger and engage the motor fully. Move the
lawn spiker forwards and backwards across the lawn. After the first aeration remove any
lose moss from the lawn. In the event that there is still moss in the lawn, aerate again at an
angle of 90 degrees to the previous aeration. (figure 6)
Warning: Do not use the lawn spiker in hard dry soil. This can damage the belt!

Cleaning and Maintenance

After use remove any moss attached to the shield. Stop the motor, remove the sparkplug
cap and tip the machine back. Clean under the shield with a brush.
If cleaning the machine with a hose, use a low pressure so as to avoid damaging the
machines stickers. Also avoid spraying the blade bearing directly. After washing the
machine it is a good idea to start the machine and let the rotor blades run without
resistance for a short period of time.
Never use a high pressure cleaner to clean the lawn spiker.
Spray exposed areas with a corrosion protective spray.
Never tilt the machine more than 20 degrees as this can result in oil leaking into the
cylinder.
Follow the motor manual instructions when performing motor maintenance.
For replacement of belt, see figure 8.

Technical specifications

Model
Working width (mm)
Total width (mm)
Length (mm)
Weight w/o fuel (kg)
Rotor diameter (mm)
Rotor speed (rev./min.)
Number of blades
Blade type (mm)
Noise for user
Handle vibration (m/s²)
Pro Cut 460
460
700
1100
66
210
2000
48
Flails,3
83.5
2.64 - 2.84
10