Operation; Turning Off The Appliance; Anomalies; Pasta Cooker With Automatic Loading - Lotus CPA-94G Aufstellungs- Und Bedienungsanleitung

1) When powering the green on-off device, the red light flashes briefly for about ½ second.
2) In the absence of water in the tank the red light keeps flashing.
3a) Turn on the tap to load the tank to the desired level, which must be higher than the minimum level probe and do not
exceed the maximum level, which is marked on the tank by the symbol (
3b) In models with automatic load, the water starts loading and you can select the desired level by pressing the button
with symbol (level button)
4) Turn the gas knob to the
At the same time, press the
5) Turn the gas knob to the
minimum level probe.
6) To set the burner to the minimum, turn the gas knob to the
Push and turn the knob into position "0". This command blocks the gas supply to both the main burner and the pilot
burner. To relight the appliance, it is necessary to turn the knob again into position
If the probe does not detect the presence of water in the tank for more than 15 sec. the system disables the heating
element: the alarm is indicated by a flashing red light
When the probe returns to detect the presence of water, the heating element is activated and the red light is turned off
NOTE: the filling phase is monitored by the system through the TIME-OUT.

PASTA COOKER WITH AUTOMATIC LOADING

If the probe does not detect the presence of water, the system will restore the correct level and after 15 sec. it will
disable the heating element: the alarm is indicated by a flashing red light
When the probe returns to detect the presence of water, the heating element is activated immediately and after 3 sec. the
automatic refilling is stopped
NOTE: the filling phase is monitored by the system through the TIME-OUT.

Slow refilling button

When the "slow refilling button" is active the system will fill the tank slowly so as to eliminate any foaming.

Level button

The "level button" defines the level of the water in the tank: high level for cooking the pasta, low level for steaming.
Important: keep clean the probe level
All manuals and user guides at all-guides.com
GB
IT

OPERATION

position and hold it down.
button to turn on the gas to light the pilot.
position: The burner will remain off until the water reaches the

TURNING OFF THE APPLIANCE

ANOMALIES

42
IE
CH
―)
position.
and press the button.