Safety Instructions For Maintenance, Inspection And Installation Work; Unauthorised Modification And Spare Parts Production; Impermissible Operating Modes; Transport And Intermediate Warehousing - Zehnder Pumpen FPS-K Basis Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

2.6 Safety instructions for maintenance, inspection and installation work

The user has to make sure that all maintenance, inspection and installation work is carried out by

authorised and qualified specialist personnel only, who has sufficiently been informed by studying the

operating instructions.

Basically, work on the machine may be carried out only at standstill. The procedure to shut down the

machine described in the operating instructions must be observed by all means.

Pumps or pump assemblies, which convey media hazardous to health, must be decontaminated.

Immediately after completing the work, all safety and protection devices have to be fitted again and/or

have to be made functional again.

Before restart, the points listed in the chapter on initial commissioning have to be observed.

Modifications or changes to the machine shall be permissible only after consultation with the

manufacturer. Original spare parts and accessories authorised by the manufacturer serve to ensure

safety. The use of other parts may results in the loss of liability for the consequences that may occur.

The operational safety of the machine supplied is ensured only when used as intended according to

Section 1 - General - of the operating instructions. The threshold values indicated in the data sheet must

by no means be exceeded.

The packaged pumping stations of series FPS-K basis must not be thrown or dropped. Moreover, they

shall be kept upright during transport.

For intermediate warehousing and conservation, it is sufficient to store the system at a cool, dark, dry and

frost-proof place. The system should stand upright.

The pumping station is completely assembled so that the pump has to be hung up and the connections

(inlet, pressure line, venting line, level control and power supply) be established only.

Inhaltsverzeichnis