General Aspects; Affiliation; Inquiries And Purchase Orders; Technical Data - Zehnder Pumpen FPS-K Basis Bedienungsanleitung

1. General aspects

1.1 Affiliation

These operating instructions are valid for the packaged pumping station FPS-K basis
In case of non-observation to the operating instructions - in particular the safety instructions - as
well as unauthorised modification of the device or the installation of non-original spare parts the
warranty claims will automatically become void. The manufacturer assumes no liability for any
damage resulting from this!
Manufacturer:
Construction sizes:
FPS-K basis with shaft installations for a single system
Pumps with a pressure outlet of 2" and a performance of up to approx. 4 kW can be used.
Status of the operating instructions: November 2022

1.2 Inquiries and purchase orders

Please send your inquiries and orders to your specialist dealer.

1.3 Technical data

clear width:
maximum outer diameter approximately:
Shaft heights:
Height of the basic
body
1200
Opening of the shaft cover:
Weight:
Inlet:
Inlet depth:
Pressure connection:
Pressure connection depth:
Switching volume:
Ventilation / cable empty conduit:
Depth of connection:
Maximum media temperature:
The shaft is protected against buoyancy up to a groundwater level of 0.5 from the lower edge of the shaft!
Materials
Shaft:
Coupling system:
Shut-off valve:
Pressure line:
Check valve:
Zehnder Pumpen GmbH
Zwönitzer Straße 19
D-08344 Grünhain-Beierfeld
Height with top piece
and BEGU cover
Class A
1365-1595
 625 mm
approx. 45 kg with mounting parts, without pump
suitable for PVC-KG DN 150
500 mm (middle of pipe) from lower edge of shaft bottom
PE HD DN 50 da= 63 mm
500 mm (middle of pipe) from lower edge of shaft bottom
approx. 100 l
2 x PVC-KG DN 100
940 mm (middle of pipe) from lower edge of shaft bottom
60 °C
PE
Cast iron GG 20
Brass
PE, stainless steel
GG 25
600 mm
approx. 800 mm
Height with top piece
and BEGU cover
Class B
1410-1640
15
Height with top piece
and BEGU cover
Class D
1445-1675