Cameo ZENIT W300i Bedienungsanleitung Seite 22

DEVICE SETTINGS (Settings)
Press MODE to access the main menu (--- Menu ---). Using the UP and DOWN controls, select the
menu item Settings (observe arrow) and confirm with ENTER.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the following submenu items (see table, select with
UP and DOWN, confirm with ENTER, change value or status with UP and DOWN, confirm with
ENTER):
Settings (device settings)
Display = flip display
Reverse
Display = Display lighting
Backlight
DMX Fail = Operational status with
DMX signal fault
Dimmer = Dimmer curve
Curve
Dimmer = Dimmer response
Response
22
On Display is rotated by 180° (e.g. for
overhead installation)
Off No rotation of the display
On Permanently on
Off Deactivation after approximately 1
minute of inactivity
Hold Last command is retained
Blackout Activates blackout
Emergency Spotlight changes to colour macro
Light "Cold White"
Linear Light intensity increases linearly with
DMX value
Exponential Light intensity can be finely adjusted
at lower DMX values and broadly
adjusted at higher DMX values
Logarithmic Light intensity can be broadly adjust-
ed at lower DMX values and finely
adjusted at higher DMX values
S-curve Light intensity can be finely adjusted
at lower and higher DMX values and
broadly adjusted at medium DMX
values.
LED Lamp responds abruptly to changes in
DMX value
Halogen Spotlight behaves like a halogen spot-
light with soft brightness changes