Cameo ZENIT W300i Bedienungsanleitung Seite 21

TIMER FUNCTION (Timer)
The timer function allows the standalone modes "Colour Macro", "Static", "Tunable White" and
"User Colour" to be timer controlled in such a way that the fade-in time can be set from 0 to 60
minutes, the dwell time from 1 to 24 hours and the fade-out time from 0 to 60 minutes. Time
control starts immediately after activating the timer function in the previously activated stand-
alone mode and remains active even if the spotlight is switched off and restarted. Select Timer
as per the procedure described above under CONFIGURE STANDALONE MODE and confirm with
ENTER. Now select "Fade In", "Dwell Time" or "Fade Out" for the individual settings (observe
arrow) and confirm with ENTER. The display will show a three-digit number field in each case. Use
UP and DOWN to set the value as required from 000 to 060 or 001 to 024. Confirm by pressing
ENTER again. Once all settings have been configured as required, activate the timer function by
selecting the submenu item "Timer On/Off" using UP and DOWN, confirm with ENTER, select "On"
and confirm again with ENTER (to deactivate the timer function, please select "Off" and confirm).
Press MODE three times to return to the main display .
----------- Stand Alone -----------
Auto
Color Macro
Static
Tunable White
User Color
Timer
Please note: The timer function is suitable for use in master/slave mode via cable.
SLAVE MODE CONFIGURATION
Press MODE to access the main menu (--- Menu ---). Using UP and DOWN, select the menu item
Slave (observe arrow) and confirm with ENTER. Connect the slave and the master units (same
model, same software version) with a DMX cable and enable one of the standalone modes on the
master unit (Auto, Color Macro, Static, Tunable White, User Color). The slave unit will now follow
the master unit. If there is no control signal, the display characters will flash. Flashing stops as
soon as a control signal is present.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
------------ Timer ------------
Timer On/Off
Fade In < 1 min >
Dwell Time < 1 h >
Fade Out < 1 min >
Mode
Slave
21