Cameo ZENIT W300i Bedienungsanleitung Seite 14

DISPLAY MODULE
A special external module with display and touch-sensitive controls is optionally available for
configuring the spotlight (product number CLZIEXDISP). The module is connected to the spotlight
using a special connecting cable. Ensure that the connections are tightly sealed and that moisture
cannot penetrate into the spotlight housing and the housing of the display module. Once the spot-
light configuration is complete, the module must be disconnected from the spotlight again and the
connection on the spotlight must be securely sealed using the cover cap. The module can now be
used to configure additional spotlights.
4 OLED DISPLAY
The OLED display shows the currently activated mode (main display), the menu items in the edit
menu and the numerical value or operating mode in certain menu items.
5 TOUCH-SENSITIVE CONTROLS
MODE
Press MODE to access the main menu. Press repeatedly to return to the main display.
ENTER
Press ENTER to access the menu levels to make value changes, and to access the sub-menus.
Confirm value changes by pressing ENTER.
UP and DOWN
Select individual menu items in the selection menu (DMX address, operating mode etc.) and in
the sub-menus. Allow changes to be made to a menu item setting such as the DMX address as
required.
PRESSURE EQUALISATION ELEMENT
The pressure equalisation element to prevent condensation forming inside the housing is located
in the base of the device. In order to ensure its proper function, the element must be protected
from contamination by regular cleaning.
HOUSING FAN
The three IP67-rated housing fans and heat sink are located on the rear of the LED unit. In order to
ensure good air circulation, do not cover the device and clean it regularly.
14
5 4 5