hanseatic HWMK714A Gebrauchsanleitung Seite 85

Problem Possible causes
Detergent residue
Too much detergent used.
on laundry.
Detergent contains bleaching
Colours of the
agent.
laundry have
Stain remover or similar was
faded.
used.
Problem Possible causes
Mains plug is not sitting
properly in the socket or is not
Appliance does not
plugged in.
work.
Socket has no voltage.
Fuse is not intact.
No wash cycle set.
Loading door is not closed
properly.
Wash cycle does
not start.
Cycle was not started.
The appliance calculates the
amount of laundry (approx.
1 minute).
Valve is closed.
Loading door is not closed
properly.
There is a kink in the water
Appliance is not
inlet hose.
receiving water.
The water inlet hose is
clogged.
Filter on inlet is clogged.
Troubleshooting table
Wash result is not satisfactory
Solutions, tips
Wash laundry with the correct dosage
of detergent.
Use colour freshener if necessary
(available at chemist's). In future, use
detergent without bleaching agent.
Malfunction
Solutions, tips
Plug it into the socket properly.
Check fuse; switch on if necessary.
Replace fuse.
Select the desired wash cycle using the
cycle selector (2).
Properly close the loading door (14)
(must hear it "snap" shut).
Press the
The program cycle starts as soon as the
appliance has determined the amount of
laundry.
Open valve.
Close loading door (14) properly.
Check water inlet hose (30); dismantle if
necessary and re-align.
Clean the filter on the water inlet hose
(30) (see page EN-30).
Clean the filter on the inlet (see
page EN-30).
Page EN-39
(6) button.