• After replacing an electrical system component, check it is
correctly wired.
GAS FRY-TOP WITH TAP
Replacing the gas tap.
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the burner, the pilot burner, the thermocouple,
the piezoelectric ignition and the igniter.
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
GAS FRY-TOP WITH VALVE
Replacing the gas valve and safety thermostat.
• Remove the control panel.
• Remove the bulb from its seat on the bottom of the hotplate.
• Remove and replace the component.
• Insert the bulb properly in its seat on the bottom of the hotpla-
te.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the burner, the pilot burner, the thermocouple,
the piezoelectric ignition and the igniter.
• Remove the control panel.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
17 CLEANING THE INTERIOR
• Check the condition of the inside of the appliance.
• Remove any built-up dirt.
• Check and clean the fumes exhaust system.
18 MAIN COMPONENTS
GAS FRY-TOP WITH TAP
• Gas tap
• Main burner
• Pilot burner
• Thermocouple
• Igniter
• Piezoelectric ignition
GAS FRY-TOP WITH VALVE
• Gas valve
• Main burner
• Pilot burner
• Thermocouple
• Igniter
• Piezoelectric ignition
• Safety thermostat
10