Omnitronic LS-622A Bedienungsanleitung Seite 21

Occupation Insert connections:
Insert-connection via
stereo 1/4" jack plug
Tip =
Output
Ring =
Input
Sleeve =
Ground / Shield
Tip
Ring
Sleeve
Strain relief clamp
Connect the mixer's output signal via a split-cable with the effector's input (tip&sleeve) and output
(ring&sleeve).
Connections
AUX
SEND RETURN
L
TAPE ON
R
TAPE IN
TAPE
For recording, connect your tape recorder or cassette deck to the
TAPE OUT-sockets. The TAPE OUT level will not be influenced by
the Main Mix fader. You can set the output level with the channel
faders, the tone controls and the GAIN control.
You can insert the tape signal via the TAPE IN-sockets. You can
activate the t ape signal via the TAPE ON-switch.
MAIN OUT
Connect the main output either via two jack plugs or the balanced
XLR-plugs.
Effector-
output
PHONES
AUX SEND/RETURN
Connect your effectors or monitor system/zone system with
the AUX SEND-sockets.
AUX is POST-fader and can be used for your effectors. You
can adjust the signal level for the AUX SEND-socket via the
AUX SEND-control.
Signal returns from the effector can be inserted via the AUX
RETURN-socket. The signal level of the AUX RETURN-
L
socket can be adjusted via the Return-control.
PHONES
R
Connect your headphones with the PHONES-socket.
TAPE OUT
TAPE IN/TAPE OUT
Effector-
input
Tip =
Output
Ring =
Input
Sleeve =
Ground / Shield
MAIN LEFT
21
Mixer output
stereo 1/4" jack plug
MAIN RIGHT
G 1 G 2
GROUP OUT