Maintenance And Cleaning - WIKA PEW-1 Serie Betriebsanleitung

6. Maintenance and cleaning

Removing the battery

Inserting the battery

Procedure
1. Open the case. Grip the upper and lower sides of the instrument with your hands and turn them in opposite directions.
2. Remove the case upwards.
3. Pull the battery connector off.
4. Remove the battery.
5. Place the new battery in the holder.
6. Connect the connector to the PCB.
7. Replace the case cover to close the sensor. Grip the upper and lower sides of the instrument with your hands and
turn them in opposite directions to tighten.
WIKA operating instructions, models PEW-1000 and PEW-1200





EN
25