Filter Version; Electrical Connection - Smeg Universal KLTI12L4X Gebrauchsanweisung

EN
90°).
! Avoid drastic changes in
the duct cross-section.
! Use a duct that is as
smooth as possible inside.
! The duct must be made
of certified material.

Filter version

The air will be degreased and
deodorised before being
returned to the room. To use
the hood in this version you
have to install an additional
activated carbon filtration
system.
Models without a suction
motor only operate in
ducting mode and must be
connected to an external
suction device (not supplied).
Connection instructions are
supplied with the external
suction unit.
Installation
Installation
The minimum distance
between the pan supports on
the hob and the lowest part
of the hood must not be less
than 50cm for electric hobs
and 65cm from gas or mixed
fuel hobs.
If the installation instructions
for the gas hob specify a
greater distance, this must be
complied with.
Electrical
connection
The mains power supply
voltage must be the same as
that indicated on the plate
inside the hood. If provided
with a plug, connect the
hood to a socket that is
compliant with current
regulations and located in an
area that is accessible, even
after installation. If it is not
fitted with a plug (direct
mains connection) or if the
19