TechniSat DIGITRADIO 3 Bedienungsanleitung Seite 86

Symptom
The remote control does not work. Batteries are inserted incorrectly or are low.
The CD does not play or skips
during playback.
Sound switches off during CD
playback.
No sound from the external input
(AUX).
If the malfunction has not been resolved, even after performing the checks
described, please contact the Technical Hotline.
86
Possible cause/remedy
Check the polarity.
Change the batteries.
IR connection interrupted.
Remove objects located between the remote
control and the device.
Distance too great.
Max. distance from the device: approx. 4
metres
The device is not in CD mode.
Faulty CD inserted.
The CD is incorrectly inserted.
Insert the CD with the labelled side facing
upwards.
The CD is dirty or faulty.
Clean the CD, use another CD.
Moisture has penetrated the CD
compartment.
Remove the CD and leave the CD
compartment open for approx. 1 hour
to dry.
The CD playing time is more than 74 minutes.
The volume is set too high.
Decrease the volume.
The CD is damaged or dirty.
Clean the CD or replace it.
The device is being exposed to vibrations.
Install the device in a location with low
vibration levels.
Is the device connected correctly?
Has AUX been selected as the input source?
Has playback been started on the external
device and has the output volume been set?