Abilica HT Rower 6.0 Bedienungsanleitung Seite 38

air resistance
Many rowing machines use air resistance. That means you're basically spinning a fan
with your rowing. This is simple and effective. There is not too much going wrong, the
only problem is that the fan can get quite dirty and dusty. If you regularly clean the air
filters (if it has), fan blades and other dirty areas, your rower will operate smoothly and
extend its service life.
Usually it involves removing the cover around the fan and cleaning all the dirty areas
with a vacuum cleaner and a damp cloth.
Magnetic resistance
Magnetic resistance transgressions are closed so much less dust and dirt can get it.
Over time, some dust will still accumulate. If you think there is too much dust in there,
you can go through the same process as for a rowing machine with air resistance.
Fluid resistance
This type is usually filled with water. Water-filled containers will be susceptible to the
fact that algae will appear. To prevent this, you can change the water regularly and
clean out the reservoir when doing this. It is also advisable to put some water
treatment tablets in it so that you do not have to clean it so often. Such tablets can be
purchased at many different retailers.
Air + magnetic resistance
This is a combination of air and magnetic resistance. Just look at the two points of the
specific maintenance points for these types of rowers.
Hydraulic resistance
Hydraulic resistors have hydraulic pistons/dampers that provide resistance when
using it. There are more turning points on a hydraulic rower than most other types.
This means more chances to develop a sound. If you regularly lubricate these moving
joints, the chances of this happening are reduced.
The actual part of the hydraulic rower that creates resistance, the piston, can leak
sometimes. There is no maintenance to be done on the piston. If it leaks, replace it.
You will probably feel that the resistance is lower when this happens. It is a good idea
to check regularly for signs of leakage. Temperature can also affect the resistance as
the oil inside the piston is affected by this.
Part Recomended maintenance
Frame Clean with a soft, clean and moist cloth. After
Computer Clean with a soft, clean and moist cloth. After
Bolts, nuts Inspect all bolts, nuts and screws.
etc. Thighten if necessary.
Movable Inspect for wear, replace parts that are
parts worn or damaged.
Drivebelt Inspect that the drive belt is sufficiently
tight, check for any wear and that
drivebelt is in the correct position.
How
often?
use
use
Monthly No
Monthly No
Yearly
38
Cleaning Lubrication
Water No
No No
No
WD-40
No No