Connection; Camera Ip Configurations By Lan; Auto Mode - Avtech NETWORK VIDEO RECORDER Serie Kurzanleitung

2. CONNECTION

2.1 Camera IP Configurations by LAN

Note: Before connecting the system and powering on the NVR, make sure a hard disk is installed in the
NVR for evidentiary recording. To know how to install a hark disk, please refer to "APPENDIX 4
HARD DISK INSTALLATION' at page 22.

2.2.1 AUTO Mode

Auto mode is to simplify the complicated network settings within three minutes. The connection mode of the LAN
port is "AUTO" by default. This mode is suitable when the LAN port of the NVR is connected to a hub.
Note: SETTING Path:
Note: The rear panel may vary depending on the models, so the above picture is only for reference.
All manuals and user guides at all-guides.com
ADVANCED CONFIG)  NETWORK  LAN  MODE.
(
3
CONNECTION