Sanus VMF322-B1 Bedienungsanleitung Seite 10

2 Mount the Wall Plate
Solid concrete or concrete block
2-1 Mark the wall
[03]
OPT
2-2 Drill pilot holes
2-3 Insert anchors
[05]
2-4 Insert lag bolts
[05]
[06]
10
[05]
[21]
[05]
[21]
13 mm
(1/2 in.)
For assistance in determining wall plate location, see Height Finder at
sanus.com.
Level the wall plate template [03] and mark the hole locations. The
third hole is for the cable management clamp [19] and is optional.
CAUTION:
Avoid potential injuries or property damage!
Mount the wall plate [01] directly onto the concrete surface.
Minimum solid concrete thickness: 203mm (8 in.).
Minimum concrete block size: 203 x 203 x 406 mm (8 x 8 x 16 in.).
Use the 10mm (3/8 in.) bit to drill the top two holes to a depth of 75mm (3 in.).
Use the 5mm 3/16 in.) bit to drill the third hole to a depth of 32mm (1¼ in.).
CAUTION:
Avoid potential injuries or property damage!
Pilot holes MUST be drilled to the depth, and with the drill bits,
stated above.
Never drill into the mortar between blocks.
75 mm (3 in.)
32 mm (1¼ in.)
Insert lag bolt anchors [05] into the top two holes. Insert anchor [21]
into the last hole.
CAUTION:
Improper use could reduce the holding power of the
lag bolt. To avoid potential injuries or property damage: Be sure the
anchors [05, 21] are seated fl ush with the concrete surface.
Insert only the top plate lag bolt [06] at this time.
CAUTION:
Improper use could reduce the holding power of the
lag bolt. To avoid potential injuries or property damage: DO NOT over-
tighten the lag bolt [06].
10 mm 5 mm
(3/8 in.) (3/16 in.)
6901-002142 05
OPT