Phone Calls; Factory Settings - Niceboy Raze Supersonic Xl Bedienungsanleitung

PHONE CALLS

To answer and afterwards end a phone call, press button (4). Long-press the same button to
reject an incoming call. Press the button twice to redial the last number called.
LIGHTING MODES
Pressing button (2) switches between individual colour modes. Long-pressing the button turns
the light off, short-pressing turns it back on.
Note: Power consumption increases when a lighting mode is active.
TRUE WIRELESS (TWS) CONNECTION
True Wireless (TWS) technology enables you to connect two Niceboy RAZE Supersonic XL
speakers and play music simultaneously in stereo.
1. Turn both Niceboy RAZE Supersonic XL speakers on and make sure they are not connected
to any Bluetooth device (mobile, notebook etc.).
2. Long-press button (3) on one of the speakers.
A tone will indicate a successful interconnection of the speakers.
3. You can now open Bluetooth settings on your device. Select "Niceboy RAZE Supersonic XL" in
the list of available devices. A tone will indicate a successful pairing..

FACTORY SETTINGS

In case of technical problems, reset the speaker to factory settings. The speaker must be
turned on. Press and hold button (8) for 8 seconds. The speaker will turn off then back on
again. The reset is now complete.
PARAMETERS
BT version:
Frequency band:
Radiofrequency power:
Transmission range:
Supported codecs:
Supported profiles:
Power output:
Impedance:
Sensitivity:
Frequency range:
Supported data storage devices:
Supported audio formats:
Battery:
5.0
2.4 GHz
≤ 2.5 mW
10 meters
SBC
A2DP, AVRCP, HFP
24 W
4 Ω
>88 dB
100 Hz – 10 kHz
USB flash drive, micro SD card, max. 32 GB
MP3, WMA, WAV
Li-Ion 2400 mAh
12