Troubleshooting - Scheppach 5906820901 Originalbetriebsanleitung

• If the signs Hg, Cd or Pb are also located below the
dustbin symbol, this stands for the following:
- Hg: Battery contains more than 0.0005% mercury
- Cd: Battery contains more than 0.002% cadmium
- Pb: Battery contains more than 0.004% lead
• Rechargeable batteries and primary batteries can
be returned free of charge to the following places:
- Public disposal or collection points (e.g. municipal
works yards)
- Sales points for primary batteries and recharge-
able batteries

14. Troubleshooting

Warning:
Switch the machine OFF and remove the mains plug from the power outlet.
Fault
The axis returns to its starting
position too quickly or too slowly
The chuck keeps loosening from the
spindle despite being reattached.
Strong noise development during
operation
Wood splinters at the opening of
the drill
The workpiece snaps out of your
hand.
The drill anneals.
36 | GB
- Take-back points of the common take-back sys-
- Take-back point of the manufacturer (if not a
• These statements are only valid for rechargeable
batteries and primary batteries sold in the countries
of the European Union and subject to the Europe-
an Directive 2006/66/EC. In countries outside the
European Union, different regulations may apply to
the disposal of rechargeable batteries and primary
batteries.
Problem
Spring tension is set incorrectly.
Dirt, grease or oil on the spindle or
on the inside of the chuck.
Wrong V-belt tension.
The spindle is too dry.
Pulley on the spindle is loose.
Pulley on the motor is loose.
No suitable base under the
workpiece.
No suitable base under the
workpiece or not firmly fixed.
Wrong speed.
No chips come out of the borehole.
Blunt drill.
Feed too low.
www.scheppach.com
tem for old device batteries
member of the common take-back system)
Solution
Setting the spring tension, see also
"Spindle return spring".
Use a household detergent to clean
the surface of the spindle and drill
chuck. See also "Installing the drill
chuck"
Set the V-belt tension. See also
"Setting the speed and V-belt
tension".
Test the spindle. See also
"Lubrication".
Check the nut on the pulley for firm
seating and tighten it if necessary.
Tighten the set screw on the motor
pulley.
Use a suitable and stable base. See
also "Adjusting the table and the
workpiece".
Reline the workpiece or fasten it.
Change the speed. See also
"Setting the speed and V-belt
tension".
Regularly drive the drill out of the
drill hole to remove the chips.
Sharpen the drill.
Increase the feed.