Bosch TDS3831100 Gebrauchsanleitung Seite 22

problem
Dirt comes out through
the soleplate.
The iron does not
produce any steam.
The ironed garment
turns dark and/or sticks
to the soleplate.
The soleplate turns
brown.
The appliance makes a
pumping sound.
loss of pressure during
ironing.
Water spots appear on
the garment during
ironing.
Water spots appear on
the garment during use
of the "pulseSteam"
function.
The hose gets hot
during use.
Water leakage from the
boiler.
The iron does not stop
steaming after placing it
on the pad (2).
if the above does not solve the problem, get in touch with our customer service.
22
B O SC H
possible causes
1. There is a build up of scale or
minerals in the boiler and iron.
2. Chemical products or additives
have been used.
1. The boiler is not switched on or
the water tank is empty.
2. The water tank is not fitted onto
the housing correctly.
1. The selected temperature is too
high and has damaged the
garment.
1. This is a regular consequence
of continued use over a long
period of time.
1. Water is being pumped into the
steam tank.
2. The water tank is not fitted onto
the housing correctly.
3. The sound will not stop.
1. Steam release button has been
activated for too long a period
of time, that is, it has been
pressed too frequently.
1. May be caused by steam
condensed on the ironing
board.
1. Water spots are caused by
steam condensation in the hose
when cooling down after use.
1. This is normal. it is caused by
the steam passing through the
hose during steam ironing.
1. Scale collector (12) located at
the bottom of the appliance is
loose.
1. "pulseSteam" function has been
activated.
Solution
1. Carry out a cleaning cycle (see
"Calc'nClean perfect" section).
2. never add products to the water.
Use tap water mixed 50% with distilled
or demineralised water. To prolong the
optimum steam function, mix tap water
with distilled water 1:1. if the tap water
in your area is very hard, mix tap water
with distilled water 1:2.
Clean the soleplate with a damp cloth.
1. Set the power button (10) to the "i"
position, and/or fill the water tank.
2. Fit the water tank back onto the
hou sing correctly.
1. Select a suitable temperature for the
material being ironed and clean the
soleplate with a damp cloth.
1. Clean the soleplate with a damp cloth.
1. This is normal.
2. Fit the water tank back onto the
hou sing correctly.
3. if the sound will not stop, do not use
the steam generator and contact an
authorised technical service centre.
1. Use the steam release button at
intervals. This improves the ironing
result as the textiles will be steamed,
dried and ironed properly.
1. Wipe the textile cover of the ironing
board, and iron any water drops to dry
them.
1. Water drops stop coming out of the
soleplate after using the "pulseSteam"
function for some time.
1. place the hose on the opposite side so
that you cannot touch the hose during
ironing.
Tighten up the scale collector.
1. Just press the trigger once again and
the iron will stop steaming at once.
* Model dependent