6- Installation - Haier HWS31GGE Bedienungsanleitung

EN
Take the appliance out of the packaging.
Remove all packaging materials including the foam base and all adhesive tape hold-
ing the accessories.
the temperature inside the appliance and its energy consumption. Do not install the appli-
ance near other heat-emitting appliances (ovens, refrigerators) without isolation.
Required space to open the door (Fig. 3):
633
499
For safety and energy reasons, the required ventilation
distance of 10 cm in all directions must be observed
(Fig. 4).
Keep ventilation openings in the appliance or in the in-built structure clear of ob-
struction. This refrigerating appliance is not intended to be used as a built-in appliance
surface.
1. Tilt the appliance slightly backwards (Fig. 5).
2. Set the adjustable front feet to the desired level
by turning them.
3. The stability can be checked by alternately
bumping on the diagonals. The slight swaying
should be the same in both directions. Other-
wise the frame can warp; possible leaking door
seals are the result. A low tendency to the rear
facilitates the closing of the door.
905 919
Installation
6
W1
W2
More than 10 cm from the top
More than
10 cm from
the left
1.
3.
3
4
More than
10 cm from
the right
5
2.