Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Alarm volume (ex factory VOLUME 2)
Select «Extended basic settings»!
With the Alarm setting switched on, a signal sounds at
regular intervals at the end of the programme.
The level can be adjusted in 3 levels.
Off
Level 1
Level 2
Level 3
Standby function (ex factory ON)
Select «Extended basic settings»!
When the standby function is switched on, the controls
switch off when no drying programme is running in
energy saving mode. All displays are dark.
Optical interface (ex factory OFF)
Select «Extended basic settings»!
If the optical interface (SCS) is switched on, customer
services can communicate with the machine by PC.
Default language (ex factory DEUTSCH)
Select «Extended basic settings»!
If another language is temporarily selected via the
select-language button
after programme end, in standby mode or after a long
standstill, the setting reverts back to the default
language.
Start time preselection (ex factory 24 HOURS)
Select «Extended basic settings»!
That function is not relevant for this model.
or the buttons
and
,
64
Cleaning and Care
Cleaning the filter support
1.
From time to time it is necessary to remove fluffs that
have accumulated inside the filter support. To do so, use
a vacuum cleaner or a cleaning brush.
2.
Run the pipe of the vacuum cleaner or the brush around
the opening for the fluff filter. Remove any residual
fluff.
3.
Replace the filter properly.
4.
Close the door.
Cleaning the moisture sensor
After longer operation, small deposits (lime, fabric
refiner) can form on the front inner side of the drum
on both sides of the longish moisture sensors. With
moisture controlled programmes, this can result in the
desired level of dryness not being reached.
Wipe deposits away with a cloth soaked in vinegar.
Cleaning the machine
Ensure that the power supply is switched off before any
cleaning, care or maintenance work.
Under no circumstances spray the machine with water
or clean it with a steam cleaner.
Do not use solvents! These substances can damage parts
of the machine, produce poisonous vapour and carry
the risk of explosion!
Casings and control areas should only be cleaned with
soap or a commercially available, solvent-free, non-ab ra-
sive cleaning product.
Werbung
Inhaltsverzeichnis
Fehlerbehebung
