Basic Settings; Extended Basic Settings; Z Drying Level; Z Crease Protection - Schulthess Spirit topLine TW 8450 Bedienungsanleitung

Basic Settings

The machine has basic settings from the factory. It can
be adapted to the user's individual needs either when
first used or later using the following functions.
The basic settings can only be changed if no dry pro-
gramme is running. To change a basic setting, it is first
necessary to hold the programme button pressed and
then press the fast forward button. The corresponding
function is shown on the digital display.
The display changes when the fast forward button
is pressed repeatedly with the programme button held
down.
The basic settings on your machine may be blocked.
However, the time setting and language selection func-
tions are available.
Example:
Drying level (ex factory NORMAL)
+
If the drying level is set to «Higher», with the moisture
controlled programmes «Cabinet dry» and «Extra dry»
the laundry will be slightly drier.
Crease protection (ex factory 30MIN)
+
When this function is switched on, a crease protection
phase of max. 60 minutes begins at the end of the pro-
gramme.
Time (the time is not set ex factory)
+
The hours can be set using the
minutes using the
Language (ex factory DEUTSCH)
To change language press repeatedly the select-language
button or press
÷
+
This setting is temporarily valid for the selected
programme and reverts back to the default language a
few minutes after completion of the programme (see
«Extended basic settings /Default language»).
Function switched off
Function switched on
button and the
button.
63

Extended basic settings

+ +
X By pressing these three buttons at the same time, the
display shows the extended basic settings.
X Repeatedly pressing the
settings.
X Pressing the
changed.
X Pressing the
settings.
Child lock (ex factory OFF)
Select «Extended basic settings»!
The child lock is to prevent accidental starting, changing
or deletion of a programme by small children.
Start a programme with the child lock switched on:
+
Hold the start button down and press the fast forward
button.
Memory function (ex factory OFF)
Select «Extended basic settings»!
With switched on memory button function, the special
programme last used is stored and appears again as first
on the display when next pressing the
Following this, the consecutive programmes can then be
selected through repeatedly pressing the button.
This way, a frequently used special programme can be
called up with only one press of the button.
With switched off function the «Reconditioning» pro-
gramme appears as first.
LCD Brightness (ex factory 150)
Select «Extended basic settings»!
The button can be used to alter the brightness of
the text on the display.
LCD Contrast (ex factory 26)
Select «Extended basic settings»!
The button can be used to alter the contrast on the
display.
Alarm volume (ex factory VOLUME 2)
Select «Extended basic settings»!
With the alarm setting switched on, a signal sounds at
regular intervals at the end of the programme.
The level can be adjusted in 3 steps.
Off
VOLUME 1
VOLUME 2
VOLUME 3
button shows the possible
button allows the settings to be
button ends the display of the
button.