Selecting Parameters And Relative Tolerances - ALPA LITEsurf Kurzanleitung

3.2 SELECTING PARAMETERS AND RELATIVE
TOLERANCES
To access the parameter selection screen, press
the main menu and then press
the Parametri (Parameters) option, then press
The following screen appears:
The parameters that can be displayed are indicated with an
icon while those that cannot be displayed are indicated
with an icon.
To access the screen for setting the parameter options, use
to move to the required parameter and then press
confirm.
The following screen appears:
To enable / disable a parameter, use
icon and then press
To enable / disable the tolerance check, use
the checkbox on the left indicated by Toll and then press
To set the upper and lower tolerance limits, use
to the numerical fields, and then use
digit that you wish to modify inside the field. Lastly, press
until you reach the required value.
Then press to return to the main menu.
to move to
several times until you reach
to confirm.
to move to the
.
to move to
to move
again to move to the
Figure 3. Parameter selection screen.
to
Figure 4. Select parameter options screen.
.
EN
IT
DE
ES
RU
PL
5