Assembly Of The Smoke Dome And The Flue Collar; Installation Of The Ashtray (If Applicable) - Dovre Attityd 100 Einbauanleitung Und Gebrauchsanweisung

3.2.2. Assembly of the smoke dome and of the flue collar
The smoke dome must
be fixed to the top of
the device and attached
by means of the clamps
supplied. Assure proper
sealing by means of the
kit or paste supplied.
It is recommended to
install the smoke dome
with its exhaust back-
wards. In case of proper
draft, it may be turned
up to 90° to the left or
to the right if required
for installation. In case
of lower draft, an angle
of maximum 60° is rec-
ommended.
The flue collar can be
installed either horizon-
tally or vertically. Fix the
flue collar on the smoke
dome with 2 bolts
M6x30, 2 nuts M6, and
4 collars Ø6xØ12. Assure proper sealing with kit or paste.

3.2.3. Installation of the ashtray (if applicable)

The optional ashtray is installed as follows:
•
Remove the plate in the middle of the bottom.
•
Clean the sealing edge and install then the ashtray holder.
•
Tighten the 4 plate screws in the ashtray holder and assure proper sealing with
kit or paste.
•
You can now install the ashtray and the grid.
•
•
•
•
•
•
•
•
Attityd 100
KIT
33
03.27649.000