Motorola TLKR T61 Bedienungsanleitung Seite 6

Battery Capacity Maintenance
1. Charge the batteries at least once every 3 months when not
in use.
2. Remove the battery from the radio after using for storage
purpose.
3. Store the batteries in temperatures between -20°C to 35°C
and in low humidity. Avoid damp conditions and corrosive
materials.
Basic Radio Operations
Read this reference guide completely before attempting to
operate the unit.
Turning your Radio On/Off
Press and hold the MENU/
Adjusting the Volume
Adjust the volume by pressing the
Adjusting the Sound (Key Beeps)
Your radio emits a beep each time one of the buttons is pressed
(except the PTT and
Press and hold the button while turning the radio ON to
switch the sound ON/OFF.
Navigating through the Menu
Your radios has two Menu functions: Select Menu and Mode
Menu.
1. To enter the Select Menu, press the SEL/
2. To enter the Mode Menu, press the MENU/
3. Additional presses of the SEL/
will advance you through the Menu.
4. To exit the Menu function, do one of the following :
4
button to turn your radio ON/OFF.
and buttons.
button).
button.
button.
button or MENU/
a. Press and hold the MENU/
b. Press and hold the PTT, MON or the
c. Wait 10 seconds until the unit automatically returns to
"Normal" mode.
Talking on Your Radio
1. Hold your radio 5–8 cm from your mouth.
2. Press and hold the PTT button while speaking. The
appears on the display.
3. Release the PTT button. You can now receive incoming
calls. When you do, the
respond, repeat procedure from step 1.
Note: When you continue to transmit for 60 seconds, the
radio emits TX Time Out tone and the
flashes. The radio will stop transmitting.
In order to speak to someone, both your radios must
be set to the same channel and Sub-Code. Refer to
"Selecting a Channel and a Sub-Code" below.
Selecting a Channel and a Sub-Code
To select a Channel:
1. SEL/ button to enter Select Menu. Advance until the
Channel indicator blinks.
2. or to the required channel.
To select a Sub-code :
1. SEL/ button to enter Select Menu. Advance until the
Sub-code indicator blinks.
2. or to the required Sub-code.
3. Exit the Select Menu.
button
button,
button
appears on the display. To
icon