Troubleshooting; Troubleshooting Table - Gardena ClassicCut Li Betriebsanleitung

4. TROUBLESHOOTING

DANGER!
Cutting injury due to the blade!
Risk of cut injury due to accidental starting.

4.1 Troubleshooting table:

Problem
Cut is not clean
Runtime is too low
Battery shear does not start or stops.
(L1)
LED blinks green [ Fig. O4 ]
Battery shear does not start or stops.
(Wp)
Error-LED blinks red [ Fig. O4 ]
Battery shear can no longer be stopped
Mower does not start or stops.
(Wp)
Error-LED lights red [ Fig. O4 ]
NOTE:
Repairs must only be done by the GARDENA service departments or specialist dealers approved by GARDENA.
v For any other malfunctions please contact the GARDENA service department.
20
9884-20.960.01.indb 20 9884-20.960.01.indb 20
v Use gloves.
v Wait for the blade to stop.
v Slide the protective cover over the blade.
Possible Cause
Blade is damaged or worn.
Blade is dirty.
Battery is empty.
Obstacle blocks the motor.
Start lever is stuck.
Battery error / battery defective.
Remedy
v Replace the blade.
v Clean the blade.
v Charge the battery.
v Remove the obstacle.
v See SAFETY WARNINGS.
v Contact the GARDENA Service.
28.07.22 11:42 28.07.22 11:42