Training With The R4 Gps; Gps Fix; Training Process; Saving And Evaluating The Training - VDO Cyclecomputing R4 GPS Handbuch

Training with the R4 GPS

Every time you switch on the device, the R4 GPS starts in the training screen to enable you to start training as quickly as possible. To switch on the device, press and hold
the START button for 3 seconds. The R4 GPS starts searching for GPS satellites immediately after it is switched on.

GPS Fix

To enable the R4 GPS to be connected to GPS/GLONASS as quickly as possible, please follow these instructions:
Find a field that is as open as possible (no trees, houses, etc. that interfere with reception)

If possible, do not move until you have received the message "GPS OK" or the GPS icon no longer flashes

Synchronize the R4 GPS with the SIGMA RIDE app as regularly as possible so that the most current GPS data is always available on the device


Training process

If you want to use GPS, wait until the message "GPS OK". Then press the START button once to start the workout. If no data is recorded, the training is either in AutoPause
or stopped. In this case you will see the training status in the display (circle element).
If you have not yet started the training, but are moving at more than 2.2 km/h, you will receive a recurring request to start the training.
Data is only recorded when it has been started.
You can change the training views for the current sport profile at any time during the training.
To do this, use the SIGMA RIDE app and follow the instructions in the
If you would like to change other settings during training, such as auto pause or tones, press and hold the START button to access the quick menu.
If you want to end the training, press the START button once. You can now start the training again by pressing the START button,
or you can leave the training and save the training session. To do this, hold down the "+" button.

Saving and evaluating the training

The training data is synchronized with the SIGMA RIDE app after the training.
You also have the option of synchronizing the data with the SIGMA RIDE app in third-party portals. Instructions for this can be found in the
data with third-party software".
You will also find an overview of the total values performed on the device.
To do this, open the main menu and select the Storage >Totals area.
"Setting training views" chapter.
chapter „Synchronizing training