Preparing For Use; Using The Appliance - Philips Philishave Turbovac HQT885/00 Bedienungsanleitung

ENGLISH
8
- Do not recharge the appliance between the trimming sessions.
- Discharge the battery completely twice a year by letting the motor
run until it stops.Then fully recharge the battery.
- If the appliance has not been used for a long period of time, it must
be fully recharged.

Preparing for use

Always comb your beard or moustache with a fine comb before you
start trimming.

Using the appliance

Corded trimming
Do not run the appliance from the mains when the battery is fully
charged.
If the battery is low, you can also use the appliance from the mains:
1 Switch the trimmer off, connect it to the mains and wait a few
seconds before switching it on.
2 If the battery is completely empty, wait a few minutes before
switching the appliance on.
Absorbing cut hairs
The suction system is activated automatically as soon as you switch the
appliance on. It absorbs cut hairs during every kind of use, i.e. trimming
with and without comb attachment and contouring.The flexible hair
guide follows the contours of the face and directs cut hairs towards the
nozzle of the vacuum mechanism.
We advise you to empty the hair-collection chamber after each
trimming session.When trimming long, dense beards it may also be
necessary to empty the hair-collection chamber during the trimming
session in order to maintain optimal suction performance (also see
chapter 'Cleaning', section 'Hair-collection chamber').