Pelgrim PKI154MAT Anleitung Seite 38

OPERATION
Using the cooking timer
1. Select a cooking zone that is switched On with a power setting.
2. Press the – and + keys simultaneously.
The time setting '0 0' of the activated cooking zone is displayed in the top two displays.
▷
At the cooking zone itself, a flashing point indicates that the timer can be set for that
cooking zone.
3. Press the - or + key to set the desired time.
When you first press the - key, the time will immediately be set to 30 minutes.
▷
If you keep the - or + key pressed, the time will run higher or lower at an increasingly
▷
faster rate.
The time setting is visible for a few seconds; then all set power levels are displayed, and
▷
at the cooking zone for which a timer has been set, a point is displayed.
▷ After the set time has elapsed, '0 0' will flash in the display, as well as the timer's point.
The cooking zone switches Off. Furthermore, you will hear a repeated short beep. Press
any key to switch Off the audible signal. If you don't do this, the signal will switch Off
automatically after 2 minutes.
Note!
If no cooking zone has been activated and you press the - and + keys simultaneously,
the time setting of the timer is displayed (no points will flash at a cooking zone)!
By again pressing the - and + keys simultaneously (multiple times), the time setting
of a cooking zone that is switched On is displayed (the point flashes at the relevant
cooking zone).
Tip
Check the remaining time by pressing the - and + keys simultaneously (multiple times).
The time that appears in the display is either from the cooking zone that is switched
On (with flashing point) or from the minute minder (no point flashes). Adjust the cooking
time as needed using the – or + key.
EN 16